You also want to watch for connectors that are just a little too loose and wobbly. I'd use alcohol to swab everything that looks like a sensor. I'd use vacuum tweezers and pliers to clean out all the little scraps of paper. Or, at least, take apart everything I felt I could get back together properly. All I had to do was put a little tape over the sticky place and everything was good again. After a few years that piece of foam fell off, leaving a sticky place. In order to soften the noise a bit, the manufacturer stuck a piece of foam on the relay arm. See, there was an open relay controlling a certain function of the printer. After 20s maybe the printer decides to reset itself.Īs an example of how subtle yet simple these things can be, here's documentation of a problem I once had. If one of these sensors is dirty or plugged up or something, it could cause the printer to stop progressing. There will be sensors all along the paper trail to tell the printer that everything is moving as it should-typically gap sensors that are tripped by plastic flags or the paper itself. Best answer: Unless somebody has had this problem before it will take a lot of time to troubleshoot.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |